Ordered and installed this on a 2010 Toyota Tacoma, this is the wiring connector kit recommended by Valley for this specific vehicle.This is a plug and play product.The T connectors worked perfectly with the connectors used by Toyota on the rear lights.Steps: 1. Undo top and bottom bolts inside the tailgate, the ones with no washer.2. The tail light is now loose, but still connected with 2 straight push-in plastic pins.Pull the light straight back to unclick the two pins and the light is loose in your hands, but still connected to the wiring.3. Use a small screw driver to press the tab on the existing connector down and separate the connector pieces.4. Click the existing wiring connector to the new wiring connectors. 5. On the driver's side tail-light, there is an additional ground wire that needs to be screwed into the sheet metal behind the light. If you confuse this and put the ground wire on the passenger side, then your blinkers will be reversed on the trailer;so be sure to put the ground wire on the driver's side.6. Tuck all wires behind the tail-light and line up the pins and push the tail-light back into "click" position 7. Insert the bolts removed step 1 and re-tighten.8.Get under truck and cable-tie loose wires up to the frame or other existing wires for support.9. Stick the modulator box to inside of bumper with double stick tape provided but be sure to cable tie it in place as well in case the double stick comes loose.Done - in maybe 20 minutes.Note: I also used some split cable tubing I had to protect the wiring around the metal edge as it comes out of the bottom of the tail-light area.Amazon packing and shipping was excellent.
Click Here to see more reviews about: Valley Tow 30127 T-Connector
Product Description:
Trailer Wire Harness
Buy cheap Valley Tow 30127 T-Connector now Get 27% OFF
0 comments:
Post a Comment